Wednesday, September 9, 2015

Review Cooler Master Hyper TX3 - CPU Cooler with 3 Direct Contact, Great Value CPU Cooler


The few days before. I'm looking for information on the Cooler Master Hyper TX3 - CPU Cooler with 3 Direct Contact Heat Pipes (RR-910-HTX3-G1), so i have to tell.


This is the best cooler money can buy? Of course not, it's $ 20. but this is probably the best cooling value w/o spending $ 50? I would be hard pressed to find better. My basic configuration: AMD Athlon II X 2 4630 (2.8 Ghz overclock slight for now at 3.2 Ghz), MSI mb, 2 GB of DDR2 ram, XFX ATI 5750. with the stock heatsink and fan this was o/c my idle temp ~ 32-34 C, approximately 52-54 C. It's not a difficult install, instructions are terrible, but for an AM2, AM3 chip is quite easy, no tools and no need to remove the motherboard from the case (can't speak for Intel chip), just takes some common sense though the thermal grease provided is pretty bad (like rubber cement). However after the TX3 was in place my idle temps are now 22-24 C and 36-38 C load. I would say that for a $ 20 cooler that is not too strong, which is a pretty good result.




Cooler Master Hyper TX3 - CPU Cooler with






Size:Hyper TX3 Cooler Master Hyper TX3 RR-910-HTX3-GP CPU Fan For Intel LGA1156/775 & AMD AM3/AM2/940/939/754 From the Manufacturer Cooler Master’s Hyper TX series has evolved with requirements of mainstream CPUs. The introduction of Hyper TX3 marks another milestone with Cooler Master's first-ever full compatibility - Intel LGA 1156 socket. The Hyper TX3 also brings back .... Read more or Check Price




Similar Products







0 comments:

Post a Comment